Before you begin…
1. Each foil packet contains
-Test Strip
-Sample Vial
-Sample Dropper Pipette
2. Do not open the foil packet until immediately prior to use.
3.Use the sample vial provided to run the test.
4.Sample pool water at the shallow end of the pool.
5.Do not re-use ant test strips, droppers, or vials.
6.Store test at 50-86°F (10-30°c).
Instructions for use
1. Open foil pouch and take out all contents.
2. Using a clean dropper, place exactly ONE dropper-ful of water into the sample vial. To draw up sample, tightly squeeze the bulb at the end of the dropper and place the open end into water sample. Release the bulb to pick up sample, then squeeze again to expel sample into vial.
3. Gently swirl vial. Let stand seven (7) minutes. Swirl vial again and return vial to flat surface.
4. Place test strip into sample vial with arrows pointing down.
5. Wait 10 minutes. Do not disturb strip or vial during this time. Reddish lines will appear on strips.
6. Take strip out of the vial and read results.
Negative: Only one line, next to number 2, is present.
Positive: Line 1 and Line 2 are present. Line 1 may be lighter in intensity or equal in intensity to line 2.
|
If only line 2 is present, test is NEGATIVE |
If no lines appear, the test is not valid. Repeat procedure, starting with Step 1, with a new test kit.
IF THE TEST IS POSITIVE, YOUR WATER SAMPLE MAY CONTAIN BACTERIA LEVELS THAT ARE DANGEROUS TO YOUR HEALTH.
